DSpace
 

Academic Knowledge Archives of Gunma Institutes >
群馬大学(Gunma University) >
50 工学研究科 >
5002 機械システム工学専攻 >
学術雑誌論文 >

Please use this identifier to cite or link to this item: http://hdl.handle.net/10087/2703

Title: CWM液滴燃焼時の残灰粒子特性
Other Titles: Characteristics of an Ash Grain Remaining after Combustion of a CWM Droplet
Authors: 松江, 孝博
新井, 雅隆
廣安, 博之
Keywords: Combustion
Fuel
Combustion Phenomena
Pulverized Coal
CWM
Droplet
Issue Date: 25-Dec-1996
Publisher: 日本機械学会
Citation: 日本機械学會論文集 B編. 62(604), 4234-4240 (1996)
Abstract: Combustion characteristics of a single CWM (Coal-Water-Mixture) droplet placed on a hot surface in a test furnace were investigated. The collapsing load of an ash grain which is formed by the combustion of the CWM droplet was also measured to clarify the relationship between the burning temperature and burn-out state of the droplet. Two stage combustion which is usually observed in pulverized coal combustion was observed in the burning sequence of the CWM droplet on the hot surface. The first stage of combustion was due to the burning of flammable gas from the volatile matter in the coal. The second stage was the char combustion of the coal. As the temperature on the hot surface increased, the collapsing load of the ash grain decreased. It reached a minimum load and then increased with an increase of the temperature of the hot surface. It was considered that the combination of the unburned coal at low temperatures and melted ash at high temperatures resulted in the hard grain of ash which had a high collapsing load.
URI: http://hdl.handle.net/10087/2703
ISSN: 0387-5016
Appears in Collections:学術雑誌論文

Files in This Item:

File Description SizeFormat
B62_4234.pdf535.19 kBAdobe PDFView/Open

Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.

 

DSpace Software Copyright © 2002-2010  Duraspace - Feedback